Installations & Replacements

If your unit is over 10–12 years old, requires frequent refrigerant top-offs, suffers from recurring compressor failures, or uses phased-out refrigerants, replacement is typically more cost-effective than continuous repairs. A new high-efficiency system significantly lowers monthly utility bills and prevents catastrophic inventory loss.

Most standard direct changeouts (such as rooftop package units, split-system condensers, or evaporator coils) take between 1 to 2 days. Complete custom walk-in installations or multi-system cold storage projects generally require 3 to 7 business days, depending on mechanical piping, structural adjustments, and permitting.

. All mechanical installations are fully compliant with California Title 24 energy standards, regional building codes, and EPA/CARB refrigerant regulations. We engineer each system with compliant low-GWP refrigerants and energy-efficient controls to guarantee pass-rate compliance.

A full replacement involves removing the entire assembly—including condensing units, piping, evaporators, and insulated panels—and installing all-new hardware. A retrofit preserves intact structural components (like the walk-in box or duct framework) while upgrading mechanicals, compressors, ECM motors, and defrost controls to improve energy efficiency at a lower upfront cost.

Modern commercial refrigeration and HVAC systems equipped with ECM fan motors, variable-speed compressors, and smart electronic expansion valves (EEVs) consume up to 30–40% less electricity than older shaded-pole and fixed-speed units, providing an immediate reduction in monthly operating overhead.

We handle the complete, EPA-certified decommissioning of your equipment. Our certified technicians safely recover and log all regulated refrigerants in compliance with EPA Section 608 guidelines, followed by responsible mechanical recycling and disposal of the old metal condensing units, coils, and cabinetry.

Every installation follows a rigorous commissioning checklist before handover. Our technicians perform a deep triple evacuation/vacuum test, precision refrigerant charging, superheat and subcooling verification, electrical voltage and amp-draw monitoring, airflow balancing, and safety cut-out testing to ensure factory-spec performance from day one.